HoldTight Solutions pioneered the concept of low-cost, easy-toachieve, and easy-to-measure contaminant-free surface preparation.
Our HoldTight®102 salt remover and flash rush inhibitor prevents
flash rust simply by removing surface contaminants. If there is NO
FLASH RUST, there are NO CONTAMINANTS. Any "stuff" on the
surface — chlorides, sulfates, nitrates, phosphates, shattered pieces of
rust, abrasive, paint, or any other debris — will pull water to the surface
and cause flash rust. And if you paint over any such stuff, sooner or
later, it will pull moisture through the coating and cause coating failure. No flash rust = a clean surface. In other words, you know it when
you see it! You don't need to use cumbersome, expensive, and applicator-sensitive field tests to prove it. This is a revolutionary old concept:
make it simple and it works better. "102" is used in conjunction with dry-blasting, wet-abrasive blasting, and water-jetting ("UHP") blasting.
It evaporates rapidly, lifting off moisture as it does, and leaves no residue. 102 is approved by most coating manufacturers for most coatings.
Contact us for your nearest distributor or to find out how to use HoldTight®102 on your job.
HoldTight Solutions Inc.
(800) 319-8802
info@holdtight.com
Write in Reader Inquiry #164
54 CoatingsPro
g
January 2013
Fax (800) 728-8861
www.holdtight.com